Pioneer RM V2550BU - Manual (Page 29)

19
GENERAL SPECIFICATIONS
299
15
430
314
19 16
420 482.6
3 RGB signal
Green (G on Sync) .............................. 1.0 Vp-p
SYNC section ...................................... 0.3 Vp-p
Blue ...................................................... 0.7 Vp-p
Input reference synchronizing signal BNC con-
nector TTL level
(or input reference synchronizing signal through
out)
Others
Power supply ................. AC 100 to 120 V (50/60 Hz)
Power consumption
...... (RMD-V3216, RMD-V3109, RMD-V3000X)
350 W, 700 VA
Operating temperature/humidity range ... 5 to 35°C
85% or less (without condensation)
External dimensions
(RMD-V3216, RMD-V3109, RMD-V3000X)
................. 482.6 (W) x 420 (D) x 314 (H) (mm)
(not including handle)
Weight
RMD-V3216 .................................................... 22.5 kg
RMD-V3109 .................................................... 22.0 kg
RMD-V3000X ................................................. 20.5 kg
Accessories
Rack mount screw M5 ............................................ 8
Rack mount washer ................................................ 8
* Up to 3 units of the RM-V2550BU can be stacked.
4x4 (16-screen) configurations are not possible.
[Fig. 2-1-3]
General Specifications of the Multi Video Processor (RMD-V3216/V3109/V3000X)
(4) Multi Video Processor (RMD-V3216/V3109/V3000X)
Side Front
Rear
unit: mm
Input signal
Input video signal (up to 4 sets can be added)
2 sets (RMD-V3216) or 1 set (RMD-V3109) or
0 set (RMD-V3000) ............................ BNC connector
1 Composite video signal .......................... 1.0 Vp-p
(75-ohm terminated)
2 Isolated Y/C signal
Y (with synchronization) ............. 1.0 Vp-p (75 ohm)
C burst level ............................. 0.286 Vp-p (75 ohm)
* Signal format 1 or 2 selectable
* Input 1 only equipped with terminating
switch, through out
Input reference synchronizing signal ... BNC connector
1 Composite synchronizing signal
............................................... 0.286 to 4.0 Vp-p
2 Composite video signal
Image level ............... 0 to 0.714 Vp-p (75 ohm)
Sync. Level ...................... 0.286 Vp-p (75 ohm)
* Equipped with terminating switch, through
out
RS-232C control input 25-pin D-sub
Output signal
Output video signal
16 sets (RMD-V3216) or 9 sets (RMD-V3109) or
0 set (RMD-V3000) ............................ BNC connector
1 Composite video signal ..... 1.0 Vp-p (75-ohm)
2 Isolated Y/C signal
Y (with synchronization) .... 1.0 Vp-p (75 ohm)
C (with burst) burst level .. 0.286 Vp-p (75 ohm)
* Simultaneous output of 1 and 2
0
0
MULTI VIDEO PROCESSOR RMD-V3216
POWER
ON
OFF
D