Pioneer RM V2550BU - Manual (Page 145)

135
ADJUSTMENTS
NOTES) ¶ The set operates as follows when the above is displayed:
• No key is pressed = Adjustment mode is canceled after about 180 seconds.
• “MAIN MENU” or “ADJ IN” pressed = Main menu reappears.
• “ADJ OUT” pressed = Adjustment mode is canceled.
• Any key from “0” to “D” pressed = Main deflection adjustment mode corresponding to that
key is set.
¶ The adjustment settings cannot be changed when the above adjustment settings are displayed.
• In the convergence adjust mode, the test cross is turned on.
= Adjustment item = Test cross
• In the white balance adjust mode, switches in the following cycle:
= Normal adjustment = White balance adjustment setting = White balance adjustment setting
item table (1) (see next page) table (2) (see next page)
31) DISP CALL
• In the deflection adjust mode, switches cyclically, as follows:
= Normal adjustment item = Main deflection adjustment setting table = Test cross
(see below)
Main deflection adjustment setting table
0. V STATIC 128 (G128)
2. V SIZE 128 (G128)
3. V M SIZE 128 (G128)
5. H SIZE 128 (G128)
6. V LI 128 (G128)
7. H BLK-L 128 - - -
8. H BLK-R 128 - - -
9. V M LIN 128 (G128)
B. H PIN 128 (G128)
D. GH LIN G128
This item (convergence GH LINEARITY) alone
can be selected and adjusted directly from
this menu. Other convergence data (adjust-
ment items within (G***)) cannot be selected
directly from this menu.
Convergence green
adjustment settings
corresponding to the
various main deflec-
tion adjustments
Remote control
unit key number
Main deflection
adjustment setting