Kodak DCS 410 - Manual (Page 66)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-22  Preparing the Camera and the Computer G
2. Place the camera in a convenient position next to the last device in
the SCSI chain of devices connected to your computer.
3. Connect the AC battery charger/adapter to the camera as described
earlier in this chapter. Although this step is optional, we recommend it
whenever the camera is connected to a computer.
4. Select the SCSI cable with the 50-pin connector at one end and the
25-pin connector at the other end.
IMPORTANT: Use only the cable supplied with the camera; do not use a
substitute cable.
25-pin Connector 50-pin Connector
5. Connect the 50-pin connector to the empty SCSI connector of the
device that is terminated internally. Make sure the connector is well
seated by pressing it into place firmly, and then pinch the thin wire
clamps over its base.
25-pin Connector
50-pin Connector
BACK OF
COMPUTER
Not
Terminated
Terminated
Internally
BACK OF ONE OR MORE
SCSI DEVICES