Kodak DCS 410 User Manual
Page 42
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-4 Quick Start G
10. Place a supported PCMCIA card into the camera.
Open the door on the side of the camera, push the PCMCIA card
firmly into place, and close the door. (Do not be startled by the red
Card Busy light that blinks briefly, or by the slight noise.) Refer to
Chapter 4.
11. Update the camera firmware.
This onetime action ensures that the most current control commands
(firmware) are loaded in the camera. Refer to Chapter 4.
A. Run Adobe Photoshop and choose
K
ODAK
DCS 400/EOS•DCS/NC2000 from the I
MPORT
submenu of
the Adobe Photoshop 4.0 F
ILE
menu. The driver image window
appears.
B. Click the camera control icon, shown below. Click the L
OAD
C
AMERA
F
IRMWARE
icon.
A.
B.