Kodak DCS 410 - Manual (Page 64)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-20  Preparing the Camera and the Computer G
B. If there is an external SCSI terminator between the end of a cable
and a SCSI connector on a device, remove the terminator, and
then reconnect the cable. (Later, if you remove the camera cable
from your computer, remember to replace this terminator.)
5. Select the SCSI cable with the 50-pin connector at one end and the
25-pin connector at the other end.
IMPORTANT: Use only the cable supplied with the camera; do not use a
substitute cable.
25-pin Connector 50-pin Connector
6. Connect the 50-pin connector to the empty connector on the last SCSI
device in the chain. Make sure the connector is well seated by press-
ing it into place firmly, and then pinch the thin wire clamps over its
base.
25-pin Connector
50-pin Connector