Kodak DCS 410 - Manual (Page 41)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
 Quick Start G 3-3
6. DCS 460 Only: Install the Calibration File.
A. Macintosh: Load the diskette with the calibration (CAL) file for
your camera. Copy the calibration file (its name ends with the
characters “.CAL”) into the folder containing your Photoshop
plug-ins (it is probably named P
LUG -I NS ). Refer to Chapter 4.
B. TWAIN (PC): Load the diskette with the calibration (CAL) file for
your camera. Run the SETUP program to install the calibration
file.
7. Attach the supplied AC battery charger/adapter.
Connect the adapter to a source supplying power within the range on
its label, and to the connector on the lower left corner of the camera
back. The first time it is used, allow the battery to charge for at least
two hours shortly before it is used. Refer to Chapter 4. The section
“Battery Charging for Optimal Capacity” in Chapter 7 includes
important battery information.
8. Set the Camera SCSI ID.
Turn on the camera system (set the Nikon N90s on/off switch to “on”),
push the camera back SCSI button once to enter SCSI mode, and then
repeatedly to rotate through SCSI IDs. Stop at the desired ID. Do not
select an ID that conflicts with any in use on your computer system.
Refer to Chapter 4.
9. Connect the camera system to your Computer.
For this step we encourage all customers to refer to the detailed
instructions in Chapter 4 to ensure that this connection is made
properly before continuing. There you will turn off your computer,
and connect the camera, a non-terminated SCSI device, to the com-
puter.