Kodak DCS 410 - Manual (Page 60)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-16  Preparing the Camera and the Computer G
5. Follow the appropriate part of this step for either a Macintosh or a PC.
MACINTOSH: Attach one 25-pin connector to the SCSI port on the
back of the Macintosh computer. Make sure the connector is well
seated by pressing it into place firmly, and then tighten both knobs on
the cable connector.
Knobs
PC: Attach the 50-pin SCSI2 connector to the SCSI2 port on the back
of the PC. Make sure the cable connector is well seated by pressing it
into place firmly, so that the spring-clips on the connector snap onto
the SCSI port.