Setting the scsi id on the camera – Kodak DCS 410 User Manual
Page 52
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-8 Preparing the Camera and the Computer G
Setting the SCSI ID on the Camera
In this section you will set the SCSI identification (ID) number for the
camera. Each SCSI device connected to the same computer must have a
different ID number.
CAUTION: This section assumes that the camera and the computer are not
currently connected. You should never change the SCSI ID on the camera
when it is connected to a computer.
1. Shut down your computer.
2. If SCSI devices other than the camera are connected to your
computer, for example a hard disk, determine their SCSI identification
numbers so that you can select a different number for the camera. If
necessary, refer to the instructions for those devices to determine how
to find their numbers.
NOTE: Since you may connect the camera to different computers, or since
you may change the external devices connected to the computer you
regularly use with the camera, you should ensure that the camera has a
unique SCSI ID each time you connect it to the computer.