Konica Minolta DI3510 - Manual (Page 78)

4
Before Making Copies
4-14 Di2510/Di3010/Di3510
Auto Panel Reset
When a specified period has passed, these will reset to the default
settings.
Conditions for auto panel resetting
● 1 minute, or a specified period after the copier is last used (factory
default settings are 1 minute).
● The magnetic card is removed from the data controller or the key
counter is removed.
✎
Note
The settings specifying whether or not and the time until the auto panel
reset operation is performed can be changed. For details, refer to
“Changing Default Settings” on page 7-6.
Energy Save Mode
In order to conserve energy, the copier will automatically enter a stand-by
mode (Energy Save mode) if no operation is performed for a specified
length of time. When the copier enters Energy Save mode, the indicator
on the [Start] key remains lit in green, but the touch panel goes off.
At this time, the copier reduces the heat of the fusing section, and goes
into Energy Save Mode.
Conditions for entering Energy Save mode
● 15 minute, or a specified period after the copier is last used (factory
default settings are 15 minute).
✎
Note
To recover from Energy Save mode, press any key in the control panel
or touch the touch panel.
The copier will not enter Energy Save Mode while printing is paused.
The settings specifying whether or not and the time until the copier
enters Energy Save mode can be changed. For details, refer to
“Changing Default Settings” on page 7-6.