Siemens SE105 - Manual (Page 9)

8
The Gigaset Router
Gigaset Router / de / A31008-E105-B100-2-19 / introduction.fm / 05.06.2003
Procedure for installation and configuration
1. First install an Ethernet network card or a wireless Network adapter such as the
Gigaset USB Adapter 11 or Gigaset PC Card 11 in the PCs you want to connect with
the Gigaset Router. The installation procedure can be found in the product's User
Guide.
2. Then install the router (see page 13).
3. Before the PCs can communicate with the router and with each other in a local
network, you have to change their network settings. Configure these network
settings on one PC first so that it can establish a connection to the router. You can
then use that PC to configure the router (see page 17).
4. In a wireless connection you establish the link from the PC's wireless network
adapter to the router. This is described in the network adapter's operating
instructions.
5. Configure the router so that the router's WAN socket can be used (see page 44).
This will require the access data from your Internet Service Provider.
6. If you want to connect more PCs to the router, configure their network settings and
set up the local network (see page 17).
7. If you want to use the router's other functions, , e. g. the comprehensive security
functions, use the router's Advanced Setup (see page 59).
i
When installing wireless network adapters you should note the
following:
The factory-set
SSID of the Gigaset SE105 dsl/cable is
ConnectionPoint.