Wan configuration – Siemens SE105 User Manual

Page 65

Configuration with Advanced Setup

Gigaset Router / de / A31008-E105-B100-2-19 / configure_router.fm / 05.06.2003

WAN Configuration

If you have configured your router with Basic Setup, you have already configured your

router's

connection. Use the WAN configuration option in Advanced Setup to

check and change these settings.
You can use your Gigaset Router as a

. With the Bridge option, the WAN

connection is configured as a link to other local networks.
The WAN menu offers the following entries:

◆

Select Dynamic IP, if the router's WAN connection is assigned a

by your Internet Service Provider. Configuration is similar to Basic Setup, as

described on page 56.

◆

Select PPPoE, if you use PPP over Ethernet (

) for your WAN connection (e. g.

for T-DSL (T-Online)). Configuration is similar to Basic Setup, as described on

◆

Select PPTP , if you use the Point-to-Point Tunneling Protocol (

) for your WAN

connection. Configuration is similar to Basic Setup, as described on page 57.

◆

Select Static IP address, if the router's WAN connection is assigned a

by your Internet Service Provider. Configuration is similar to Basic Setup, as

described on page 55.

◆

Select DNS, if you want to use a particular

◆

Select Bridge, if you want to use your router as a bridge (see page 67).

Remember that configuration saves the access data for your WAN

connection in the router. Before passing your router on to somebody else

or having your dealer replace it, you should first restore the factory

settings. Otherwise unauthorised persons may use your Internet access

data at your expense. To reset the router, press the reset button on the

back for at least 5 seconds.