Seiko Instruments SII Black-and-White Raster Plotter LP-1020 - Manual (Page 47)

2-5
Chapter 2 Basic operations
When a job is saved, the following message appears and the device stands
by for selection.
When a job is not saved, this message is omitted.
Under normal conditions, the display reads “INITIALIZING STANDBY”
and is changed to the following message.
The message is changed to the “WARMING UP".
The message indicates that the device is now online (“PRINT READY”).
A “PRINT READY” message indicates that the device is functioning
normally.
D E L E T E J O B ?
Y = E N T E R N = C A N C E L
S Y S T E M V E R S I O N
0 1 A
W A R M I N G U P n n n
P R I N T R E A D Y
If a key input is not made,
this message will time-out
after about 10 seconds
and the device starts up
with the job in saved
condition.
Warm up will take about 4
minutes. (about 8 minutes
with LP-1020L)
nnn: a count down for the
warm up is displayed.
▼Turning the power on and off