Turning the power on and off – Seiko Instruments SII Black-and-White Raster Plotter LP-1020 User Manual
Page 45
2-3
Chapter 2 Basic operations
◆While data is being processed, do not turn off the main
power switch. Doing so may damage the system.
◆When the power is on and the Main power switch is turned
off, or when the power goes out due to blackout etc.,
restoring the power (turning the Main power switch back on
or resetting from a blackout) is the first step, but will not turn
the plotter on. You must also turn ON the power key on the
control panel.
Main power switch
Power key
Notes
Control panel
Turning the power on and off
This device has two power switches: the main power switch located at
the lower-left as seen from the rear of the device; and the power key on
the control panel.
The device power is turned on by first turning on the main power switch, and
then pressing the device’s control panel power key.