Symbol Technologies SPT 1500 - Manual (Page 119)

8-9
Applications: HotSync
Conducting a HotSync Operation via Modem
You can use a modem to synchronize your SPT 1500 terminal when you are away from your
computer.
Note: You must conduct an initial local HotSync operation using the SPT
1500 terminal cradle before you perform a modem HotSync
operation.
To perform a HotSync operation via modem you need:
t A modem connected to your computer
t A modem connected to your SPT 1500 terminal with a special modem cable. (The
cradle is not used for a modem HotSync operation.) See Technical Support, Service
and Repair on page 16-12 for details on ordering this special cable.
t The Palm Desktop software configured for use with a modem as described earlier in
this chapter in Selecting HotSync Setup Options on page 8-4
Preparing Your Computer for a Modem HotSync Operation
There are a few steps you must perform to prepare your computer for a modem HotSync
operation. Be sure to perform these steps before you leave your office so that your computer
is ready to receive a call from your SPT 1500 terminal. See Selecting HotSync Setup Options
on page 8-4 earlier in this chapter.
To prepare your computer for a modem HotSync operation:
1. Confirm that the computer modem is connected and turned on, and that no
communications applications, such as fax or telephony software, are running on a
COM port.
Note: Make sure the computer is disconnected from all online services, such
as America Online ® (AOL) and CompuServe ® . This helps to avoid
conflicts with the COM port.
2. Start HotSync Manager if it is not already running, and click Modem from the
HotSync Manager menu.