GE XLG3 - Manual (Page 139)

130 Appendix B Agency Certifications GE Inspection Technologies XLG3 VideoProbe System
FCC Compliance
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
FCC Class A Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Caution: Any changes or modifications made to this device that are not expressly
approved by GE Inspection Technologies may void the user's authority to operate the
equipment.
To maintain compliance with FCC rules and regulations, cables connected to this device
must be shielded cables, in which the cable shield wire(s) have been grounded (tied) to
the connector shell.
Canadian Notice
This equipment does not exceed the Class A limits for radio noise emissions as described
in the Radio Interference Regulations of the Canadian Department of Communications.
Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites
applicables aux appareils numeriques de la classe A prescrites dans le Reglement sur le
brouillage radioelectrique edicte par le ministere des Communications du Canada.