StorageTek 9840 - Manual (Page 212)

Clean Fibre Channel Components
8-4 Sixth Edition 95741
■
Clean Fibre Channel Components
The following information describes a cleaning process for fibre channel
components such as connectors, GBICs, and plugs.
Fibre Channel Transmission
The 9840 Tape Drive uses a laser multi-mode transmitter-receiver (transceiver)
module. There are several warnings which everyone must know and
understand for their personal safety.
Note: Ensure you follow the instructions on “Fiber Optic Safety” in Chapter 2,
“Safety and Handling,” and the warnings listed in this section.
Cleaning Materials
Use the following list of materials to clean fibre-optic components:
• Alcohol pads
• Cloth pads
• Texwipe microswab
• Texwipe foam swab
Fibre Channel Cable
To clean a fibre channel cable (such as the one in Figure 8-1 ):
1. Blow any dust from the ferrule and the end of the connector using
compressed air by positioning the air nozzle approximately 50 mm (2 in.)
away from the connector and blowing for 5 seconds.
.
Figure 8-1. Fibre Channel Connector
1. Fibre Channel Cable Dust Covers
2. Fibre Channel Cable Housing
C53527
1
2