StorageTek 9840 - Manual (Page 128)

Power On/Off CSL
5-12 Sixth Edition 95741
■
Power On/Off CSL
This section provides a process to power on/off the CSL. Figure 5-9 provides
locations of the Power switch, power cord, terminator, and cable for a CSL SCSI
interface.
Note: The CSL Power switch and power cord are located on the rear of the
CSL. The switch and cord are in the same locations on a SCSI or Fibre
Channel CSL.
Power On
1. Ensure the power cord is attached to the receptacle on the rear of the CSL.
Note: The power cord and applicable interface cable (SCSI) should have been
attached during initial installation.
2. If the power cord is not attached to the CSL, do the following:
a. Attach the female end of the power cord to the CSL receptacle.
b. Attach the male end of the power cord to a power outlet.
3. Press the Power switch on the rear of the CSL to ON (1).
4. Verify that the CSL powers on.
Note: A steady asterisk on the operator panel indicates a successful IPL
completion, the drive is online, but not loaded with a cartridge.
Figure 5-9. CSL Power
1. Power switch
2. Power cord
3. SCSI cable
4. Terminator
C53661
4
1
2
3