StorageTek 9840 - Manual (Page 173)

95741 Sixth Edition 6-17
Fibre Channel Change Configuration
Port A/B Custom/Normal WWN Submenu
Note: This submenu only appears if a Custom WWN is in use, or is being created.
WWN Custom
WWN Normal
Custom is default selection.
Normal selection recalls the
stored Normal WWN from the
drive EEPROM.
Currently, a password (use 500) is
required to save a new Custom
WWN, or to reset a Custom WWN
back to the stored Normal WWN.
Password requirement will not be
in future firmware releases.
1. Press Menu to invoke a Custom
WWN, and advance to the next
submenu; or
,
2. Press Select to toggle option;
then, press Menu to reset WWN to
the stored Normal WWN, and
advance to the next submenu.
Note: If valid Password is not entered, change to the WWN will not be saved.
Port B Attributes Submenu
Cfg PrtB ? View or change Port B attributes
as defined in the preceding Port
A/B Attributes Submenus, starting
on
page 6-14 .
1. Press Select (Yes) to enter the
Port A/B Attributes submenus, or
2. Press Menu (No) to bypass.
Tape Bar Submenu
Tape Bar Y
Tape Bar N
Selects a barchart that displays
how much tape is written and
how much tape has been read.
Deselects the barchart display.
See “Tape Bar” on page 1-14 for
additional information.
1. Press Menu to bypass, or
2. Press Select to toggle option;
then, press Menu to set, and
advance to the next submenu.
Note: Manufacturing ships drive with the Tape Bar N option selected
Language Selection Submenu
Language ?
Defaults to last saved selection.
Selects display language:
English, Espanol, Francais,
Italiano, or Deutscher.
1. Press Menu to bypass, or
2. Press Select until desired option
is displayed; then, press Menu to
set, and advance to the next
submenu.
Note: Manufacturing ships drive with the English option selected
Table 6-1. Menu Table—Fibre Channel Configuration (Continued)
Options Notes Procedure