StorageTek 9840 - Manual (Page 202)

Dislodge a Stuck Tape
7-6 Sixth Edition 95741
xxxx:Dmpyy Alternates with an asterisk (*)
after completion of an IPL,
where:
xxxx = FSC of the last dump
data saved to the EEPROM
yy = number of uncollected
dumps in EEPROM
Optionally move the dump(s) to the host
or tape
See the dump instructions in Chapter 4,
“Getting Started,” or Chapter 7, “Error and
Recovery.”
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
Fix_CfgErr Upon IPL, the configuration
checksum does not match. Go to “Save Fails or Fix_CfgErr Indication”
on page 7-9 .
INIT(xxxx) An initialization error
occurred. Initiate IPL.
If that fails, replace the drive or CSL.
IPL Pend This is displayed for one
second when the IPL switch is
pressed. Wait until the IPL completes automatically.
Load CC The common controller code
is loading. No action necessary.
Loading The tape cartridge is being
loaded. No action necessary.
Load FIBRE This is the normal display
during a boot. Wait for the IPL to complete.
Load(xxxx) The load or unload operation
failed. If another tape also fails to load, IPL the
drive or CSL.
If the failure persists, replace the drive or
CSL.
If another tape works, the tape is suspect.
Load SCSI This is the normal display
during a boot. Wait for the IPL to complete.
Locating The drive or CSL is
performing a high-speed
seek. No action necessary.
Memory Err The RAM failed during an IPL. Initiate IPL again. If that fails, replace the
drive or CSL.
NT Ready A A VolSafe tape is in process of
manual unload. Wait until unload operation completes
NT Ready F A write-protected tape is in
process of manual unload. Wait until unload operation completes
Table 7-2. Error Displays and Instructions (Continued)