Sanyo DSR-3706PA - Manual (Page 6)

English
Safety precautions
5 Foreword
Follow the points outlined below for proper use
b Hard disk
This unit is loaded with a hard disk drive. Stored data on this unit may be damaged/lost through hard-disk breakdowns caused
by shock/vibration.
Follow the items outlined below when placing, transporting, and operating this unit.
Warning
G This unit is designed to be positioned horizontally.
Do not position vertically.
G Do not expose to shock or vibration and do not
transport while power is turned on.
Always turn the power off, even when moving in and out of
racks.
G Do not remove the power cable while recording or
playing back.
G Do not move the unit for approximately 30 seconds
after turning the power off.
The hard disk is rotating for a short duration after the
power is turned off. The unit is further susceptible to
damages through shock and vibration in this state
compared to when the power is turned on. Do not move it.
G Do not expose to shock or vibration.
Avoid placing this unit directly on the floor. Make sure that
the four stands attached to the base of this unit are used,
when placing it on the floor.
G Always use the original packaging (packaging
provided at the time of purchase), when delivering.
Use the packaging materials provided during the original
purchase when the unit or a single internal component is
going to be delivered. Deliver using a method that causes
the least amount of shock and/or damage to this unit.
Caution
G Inspecting for abnormalities in the hard disk drive and
the cooling fan
This unit is designed to automatically check the drive and
cooling fan when the power is turned on. Replacement
parts will be necessary if abnormalities are detected.
Images will have to be saved and initialization will have to
take place if there is a fault with the drive. Consult the
dealership where this unit was purchased for details.
G Wear in the hard disk drive and the cooling fan
The hard disk drive and cooling fan are consumable
items.
Replace the parts stated below when using the unit in a
25°C environment. The replacement timings listed are
approximate and do not guarantee the performance or life
expectancy of the part in question.
• Hard disk: 2 years
• Cooling fan: 3 years
• Damper: 2 years
Consult the dealership where the unit was purchased
for replacement drives.
• The drive is vulnerable to static electricity shocks. Take
the appropriate measures to prevent exposure to static
electricity.
• Unpackaged drives should be placed horizontally with
their base facing upwards on top of a soft cloth.
Exposing the drive to shocks and vibration may cause
breakdowns.
• Do not expose the drive to shocks and vibrations while
removing/tightening the screws during replacement.
Firmly tighten the screws after replacement.
Cooling fan