Searching for recorded video, 25 how to use, Emotion detection search (continued) – Sanyo DSR-3706PA User Manual

Page 26

English

Searching for recorded video

How to use

Press the SEARCH button during recording or live
video.

Turn the J-dial, select "MOTION DETECTION
SEARCH", and turn the S-dial clockwise.

The screen
appears.

The "SEARCHING" starts blinking.

☞

Press the SEARCH button to cancel the search
mode.

Operation returns to the normal screen.

Turn the S-dial clockwise.

The "ALARM" starts blinking.

Select the desired recording area (example: ALARM
& NORMAL) by turning the J-dial, and then turn the
S-dial clockwise.

Selections: ALARM/NORMAL/ALARM & NORMAL

"SEARCHING" of END starts blinking again, the search
is over.

Select CHANNEL by turning the J-dial and then turn
the S-dial clockwise.

The "– –" starts blinking.

Select the desired channel (example: camera 4) by
turning the J-dial, and then turn the S-dial
clockwise.

The cursor moves to the START PREVIEW field.

Turn the S-dial clockwise.

The screen switches to the SEARCH 2> screen, and the channel 4 preview screen
is displayed.

Turn the S-dial clockwise, and set the number using
the J-dial. Turn the S-dial clockwise again, and
repeat this to set the date and time for the start of
the search.

Example: October 28, 2006 8:30pm

When the settings are complete, turn the S-dial
clockwise.

Repeat the same steps as shown at 8 to set the
end date and time for the search.

Example: November 29, 2006 8:30pm

The cursor moves to the MOTION SENSOR field.

Turn the S-dial clockwise.

The motion sensor setting screen is displayed.

Setting the motion sensor

Turn the J-dial to move the cursor to the desired
position of the sensor, and then turn the S-dial
clockwise.
–

: Sensor is not set

: Sensor is set

After switching the sensor from unset to set, the
same operation can be used to set sensors at other
locations.

Turn the J-dial to move the cursor to "LEVEL:
OFF", and then turn the S-dial clockwise.
The "OFF" starts blinking.

Selections: OFF/1/2/.../9/10 (low sensitivity)

Turn the J-dial to set "LEVEL: OFF" to [5], and
then turn the S-dial clockwise twice.
The screen
returns.

For searching the "PREVIEW" or "VIEW" screens,
continue at P26 without exiting the current search.

Press the SEARCH button to exit the search mode.

The normal live video display returns.

Motion detection search (continued)

(J)

(S)

SEARCH FROM : ALARM

START : 01-01-06 00:40

END : 05-01-06 10:17

CHANNEL : --

START PREVIEW ->

MOTION DETECTION SEARCH

CHANNEL : --

START PREVIEW ->

START :
28-10-06 20:30

If you set the motion search to a specific channel
(camera number), only the video from the specified
channel will be played. The camera title, date and time
may not be displayed fully on the screen.

END :
29-11-06 20:30

SEARCH FROM : ALARM & NORMAL/ CHANNEL : 4

START :

28-10-06 20:30

END :

29-11-06 20:30

MOTION SENSOR ->

PREVIEW ->

VIEW ->

MOVE:JOG SELECT:SHUTTLE

- - - - - - - - - -

LEVEL : OFF EXIT

- - - - - - - - - -

- - - - - -

- - - - - - - - - -

LEVEL : 5 EXIT

(S)

(J)