McDATA 4300 - Manual (Page 68)

3-4 McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Maintenence Analysis Procedures
410 Switch reset. No action required.
411 Firmware fault. Go to MAP 0200 .
412 CTP watchdog timer reset. Go to Collect Maintenance Data .
421 Firmware download complete. No action required.
423 CTP firmware download initiated. No action required.
426 Multiple ECC single-bit errors occurred. Go to MAP 0400 .
433 Non-recoverable Ethernet fault. Go to MAP 0400 .
440 Embedded port hardware failed. Go to MAP 0400 .
442 Embedded port anomaly detected. No action required.
445 ASIC detected a system anomaly. No action required.
453 New feature key installed. No action required.
506 Fibre Channel port failure. Go to MAP 0500 .
507 Loopback diagnostics port failure. Go to MAP 0500 .
508 Fibre Channel port anomaly detected. No action required.
510 Optical transceiver hot-insertion initiated. No action required.
512 Optical transceiver nonfatal error. Go to MAP 0500 .
513 Optical transceiver hot-removal completed. No action required.
514 Optical transceiver failure. Go to MAP 0500
515 Optical digital diagnostics warning threshold exceeded. Go to MAP 0500 .
516 Optical digital diagnostics alarm threshold exceeded. Go to MAP 0500 .
523 FL_Port open request failed. No action required.
524 No AL_PA acquired. No action required.
525 FL_Port arbitration timeout. No action required.
581 Implicit incident. Go to MAP 0500 .
582 Bit error threshold exceeded. Go to MAP 0500 .
Table 3-3 Event Codes versus Maintenance Action (Continued)
Event
Code Explanation Action