Configure port npiv, Configure snmp, Configure port npiv -16 configure snmp -16 – McDATA 4300 User Manual
Page 50: Snmp view -16
2
2-16
McDATA Sphereon 4300 Fabric Switch Installation and Service Manual
Installation Tasks
Configure Port NPIV
NPIV allows multiple (up to 256) Fibre Channel addresses to be
assigned to a node (N_Port). The NPIV feature must be installed.
Refer to
for instructions. Perform this
procedure to configure ports for NPIV connectivity.
1. Select Ports and NPIV from the Configure menu at any view. The
NPIV View displays.
2. Click Enable to activate product NPIV operation.
3. To set a port to a user-specified value, type the desired value
(1 through 256) in the Login column.
4. Click OK to save and activate changes.
Configure SNMP
Perform this procedure to configure names, write authorizations,
addresses, and user datagram protocol (UDP) port numbers for
SNMP trap message recipients. To configure recipient workstations:
1. Select SNMP from the Configure menu at any view. The SNMP
View displays (
).
Figure 2-8
SNMP View