McDATA 4300 - Manual (Page 37)

2
Installation Tasks 2-3
Installation Tasks
• Support is available for a browser-capable PC and Internet
connectivity to support the product-resident EFCM Basic Edition
interface.
• Support equipment and technical personnel are available for the
installation.
• The required number and type of fiber-optic jumper cables are
delivered and available. Ensure cables are the correct length and
have the required connectors.
• A Fabricenter cabinet or customer-supplied 19-inch equipment
rack and associated hardware are available (optional).
• Remote workstations or simple network management protocol
(SNMP) workstations are available (optional). Workstations are
customer-supplied and connected through a public or dedicated
LAN segment.
Task 2: Unpack, Inspect, and Install the Product
The following paragraphs provide instructions to unpack, inspect,
and install one or more switches. If the switch is delivered in a
Fabricenter equipment cabinet, go to
Task 3: Configure Product at the
EFCM Basic Edition Interface .
Unpack and Inspect
Switch Unpack and inspect switch(es) as follows:
1. Inspect shipping container(s) for damage. If a container is
damaged, ensure a freight carrier representative is present when
the container is opened. Unpack shipping container(s) and
inspect each item for damage. Ensure packaged items correspond
to items listed on the enclosed bill of materials.
2. If items are damaged or missing, contact the solution center:
Phone: (800) 752-4572 or (720) 558-3910
Fax: (720) 558-3851
E-mail: [email protected]