Motorola MC68VZ328 - Manual (Page 327)

AC Electrical Characteristics
Electrical Characteristics 19-11
19.3.8 DRAM Hidden Refresh Cycle (Normal Mode)
Figure 19-8 on page 19-12 shows the DRAM hidden refresh cycle timing diagram for normal mode. The
signal values and units of measure for this figure are found in Table 19-10 on page 19-12. Detailed
information about the operation of individual signals can be found in Chapter 7, “DRAM Controller.”
Table 19-9. DRAM Write Cycle 16-Bit Access (CPU Bus Master) Timing Parameters
Number Characteristic
(3.0 ± 0.3) V
Unit
Minimum Maximum
1 Row address valid to RASx asserted 40 — ns
2 DWE asserted before CASx asserted 25 — ns
3 OE negated before RASx asserted 0 — ns
4 RASx asserted before row address invalid
(MSW = 0,1) 12,27 — ns
5 Column address valid to CASx asserted
(MSW = 0,1) 10,25 — ns
6 RASx asserted to CASx asserted (MSW = 0,1) 28,58 — ns
7 RASx pulse width (SLW = 0,1) 90,120 — ns
8 CASx pulse width (BC[1:0] = 00,01,10,11) 28,58,88,118 — ns
9 Data-out valid before CASx asserted 25 — ns
10 Data-out hold after CASx negated 25 — ns
11 DWE negated after CASx negated 0 — ns
12 CASx asserted before column address invalid 50 — ns
13 RASx negated after CASx negated 28 — ns
14 RASx precharge time (SLW = 0,1) 50,118 — ns
Note: RASx stands for RAS0 and RAS1. CASx stands for CAS0 and CAS1.
Note: MSW is bit 5, SLW is bit 3, and BC[1:0] comprises bits 13–12 in the DRAMC register. When the table
identifies these bits, the sequence of their listed values corresponds to the sequence of timing data provided.