Motorola 2200 - Manual (Page 229)

229
VoIP settings (supported models)
Voice-over-IP (VoIP) refers to the ability to make voice telephone calls over the Internet. This differs from
traditional phone calls that use the Public Switched Telephone Network (PSTN). VoIP calls use an Inter-
net protocol, Session Initiation Protocol (SIP), to transmit sound over a network or the Internet in the
form of data packets. Cer tain Motorola Netopia
®
Gateway models have two separate voice por ts for
connecting telephone handsets. These models suppor t VoIP. If your Gateway is a VoIP model, you can
configure the VoIP features.
set ip client voip ip-interface
[ no-restrict | ip-dsl-vcc1... | ppp-vcc2... | ppp-enet-x... | ip-enet-x... ]
This command allows you to specify which WAN IP inter face to use for VoIP traffic. The option list will
display the WAN IP inter face name if the inter face is enabled.
❑ no-restrict: default behavior — use the default (first WAN IP) interface.
❑ ip-dsl-vcc1, 2, 3: will show IP WAN interface.
❑ ppp-vcc1, 2, 3: will show IP PPP WAN interface.
❑ ip-enet-x: will show IP over Ethernet over VDSL/Ethernet WAN.
❑ ppp-enet-x: will show PPP over Ethernet over VDSL/Ethernet WAN.
set voip phone [ 1 | 2 ] sip-option [ off | on ]
Turns SIP on or off for the specified phone. Default is off.
set voip phone [ 1 | 2 ] sip-proxy-server [ server_name | ip_address ]
Specifies the SIP proxy ser ver for the specified phone by fully qualified ser ver name or IP address.
set voip phone [ 1 | 2 ] sip-proxy-server-transport [ UDP | TCP | TLS ]
Specifies the SIP proxy ser ver transpor t protocol for the specified phone. Default is UDP.
set voip phone [ 1 | 2 ] sip-registrar-setting sip-registrar-server
[
server_name | ip_address ]
Specifies the SIP registration ser ver for the specified phone by fully qualified ser ver name or IP
address.
set voip phone [ 1 | 2 ] sip-registrar-setting
sip-registrar-server-transport [ UDP | TCP | TLS ]
Specifies the SIP registration ser ver transpor t protocol for the specified phone. Default is UDP.
set voip phone [ 1 | 2 ] sip-registrar-setting sip-expires-time [ 0 - 65535 ]
Specifies the SIP registration ser ver time-out duration from 0 – 65535 seconds for the specified phone.
Default is
3600 (1 hour).