Motorola 2200 - Manual (Page 151)

151
Your Ser vice Provider will indicate the required vpi number.
set atm [vcc n ] vci { 0 ... 65535 }
Select the vir tual channel identifier (vci) for VCC n. Your Ser vice Provider will indicate the required vci
number.
set atm [vccn] encap { ppp-vcmux | ppp-llc | ether-llc |
ip-llc | ppoe-vcmux | pppoe-llc }
Select the encapsulation mode for VCC n. The options are:
Your Ser vice Provider will indicate the required encapsulation mode.
set atm [vccn] pppoe-sessions { 1 ... 8 }
Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The total num-
ber of
pppoe-sessions and PPPoE VCCs configured must be less than or equal to eight.
Bridging Settings
Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to for ward non-
TCP/IP traffic from one network to another. When bridging is enabled, the Motorola Netopia® Gateway
maintains a table of up to 512 MAC addresses. Entries that are not used within 30 seconds are
dropped. If the bridging table fills up, the oldest table entries are dropped to make room for new
entries.
Vir tual circuits that use IP framing cannot be bridged.
☛
NOTE:
For bridging in the 3341 (or any model with a USB por t), you cannot set the bridge option
off, or bridge ethernet option off; these are on by default because of the USB port.
Common Commands
set bridge sys-bridge {on | off }
Enables or disables bridging ser vices in the Motorola Netopia® Gateway. You must enable bridging ser-
vices within the Motorola Netopia® Gateway before you can enable bridging for a specific inter face.
ppp-vcmux PPP over ATM, VC-muxed
ppp-llc PPP over ATM, LLC-SNAP
ether-llc RFC-1483, bridged Ethernet, LLC-SNAP
ip-llc RFC-1483, routed IP, LLC-SNAP
pppoe-vcmux PPP over Ethernet, VC-muxed
pppoe-llc PPP over Ethernet, LLC-SNAP