Motorola 2200 - Manual (Page 187)

187
PPPoE /PPPoA Settings
You can use the following commands to configure basic settings, por t authentication settings, and peer
authentication settings for PPP inter faces on your Motorola Netopia® Gateway.
Configuring Basic PPP Settings.
☛
NOTE:
For the DSL platform you must identify the vir tual PPP inter face [ vccn], a number from 1 to
8.
set ppp module [vccn] option { on | off }
Enables or disables PPP on the Motorola Netopia
®
Gateway.
set ppp module [vccn] auto-connect { on | off }
Suppor ts manual mode required for some vendors. The default on is not normally changed. If auto-con-
nect is disabled ( off), you must manually start/stop a ppp connection.
set ppp module [vccn] mru integer
Specifies the Maximum Receive Unit (MRU) for the PPP inter face. The integer argument can be any
number between 128 and 1492 for PPPoE; 1500 other wise.
set ppp module [vccn] magic-number { on | off }
Enables or disables LCP magic number negotiation.
set ppp module [vccn] protocol-compression { on | off }
Specifies whether you want the Motorola Netopia® Gateway to compress the PPP Protocol field when it
transmits datagrams over the PPP link.
set ppp module [vccn] lcp-echo-requests { on | off }
Specifies whether you want your Motorola Netopia® Gateway to send LCP echo requests. You should
turn off LCP echoing if you do not want the Motorola Netopia® Gateway to drop a PPP link to a nonre-
sponsive peer.
set ppp module [vccn] echo-period integer
Specifies the number of seconds the Motorola Netopia® Gateway should wait before sending another
echo from an LCP echo request. The integer argument can be any number from between 5 and 300
(seconds).