Motorola 2200 - Manual (Page 171)

171
Static ARP Settings
Your Motorola Netopia® Gateway maintains a dynamic Address Resolution Protocol (ARP) table to map
IP addresses to Ethernet (MAC) addresses. Your Motorola Netopia® Gateway populates this ARP table
dynamically, by retrieving IP address/MAC address pairs only when it needs them. Optionally, you can
define static ARP entries to map IP addresses to their corresponding Ethernet MAC addresses. Unlike
dynamic ARP table entries, static ARP table entries do not time out.
You can configure as many as 16 static ARP table entries for a Motorola Netopia® Gateway. Use the fol-
lowing commands to add static ARP entries to the Motorola Netopia® Gateway static ARP table:
set ip static-arp ip-address ip_address
Specifies the IP address for the static ARP entr y. Enter an IP address in the ip_address argument in
dotted decimal format. The ip_address argument cannot be 0.0.0.0.
set ip static-arp ip-address ip_address hardware-address MAC_address
Specifies the Ethernet hardware address for the static ARP entr y. Enter an Ethernet hardware address
in the MAC_address argument in
nn.nn.nn.nn.nn.nn (hexadecimal) format.
IGMP Forwarding
set ip igmp-forwarding [ off | on ]
Turns IP IGMP for warding off or on. The default is off.
IPsec Passthrough
set ip ipsec-passthrough [ off | on ]
Turns IPsec client passthrough off or on. The default is on.