beautypg.com

Additional sub – Motorola 2200 User Manual

Page 168

background image

Administrator’s Handbook

168

If you specify

v2-MD5, you must also specify a rip-send-key. Keys are ASCII strings with a maximum of

31 characters, and must match the other Gateway(s) keys for proper operation of MD5 suppor t.

Depending on your network needs, you can configure your Motorola Netopia® Gateway to suppor t RIP-
1, RIP-2, or RIP-2MD5.

set ip ethernet A rip-receive { off | v1 | v2 | v1-compat | v2-MD5 }

Specifies whether the Motorola Netopia® Gateway should use Routing Information Protocol (RIP) broad-
casts to update its routing tables with information received from other Gateways on your network.

If you specify

v2-MD5, you must also specify a rip-receive-key. Keys are ASCII strings with a maximum

of 31 characters, and must match the other Gateway(s) keys for proper operation of MD5 suppor t.

Additional subnets

See

“DHCP Settings” on page 153

for subnet range configuration commands.

set ip ethernet A subnet [ 2 ... 8 ] option [ on | off ]

Enables or disables additional LAN subnets. Up to seven additional subnets may be configured.

set ip ethernet A subnet

n

address

ip_address

Specifies an IP address for the subnet

n, when subnet n option is on.

set ip ethernet A subnet

n

netmask

netmask

Specifies the subnet mask for the subnet

n, when subnet n option is on.

Default IP Gateway Settings

set ip gateway option { on | off }

Specifies whether the Motorola Netopia® Gateway should send packets to a default Gateway if it does
not know how to reach the destination host.

set ip gateway interface {

ip-address | ppp-vccn }

Specifies how the Motorola Netopia

®

Gateway should route information to the default Gateway. If you

select ip-address, you must enter the IP address of a host on a local or remote network. If you spec-

ify ppp, the Motorola Netopia

®

unit uses the default gateway being used by the remote PPP peer.

IP-over-PPP Settings.

Use the following commands to configure settings for routing IP over a vir tual

PPP inter face.

NOTE:

For a DSL platform you must identify the vir tual PPP inter face [

vccn], a number from 1 to

8.