Motorola 2200 - Manual (Page 144)

Administrator’s Handbook
144
who
Displays the names of the current shell and PPP users.
WAN Commands
atmping vccn [ segment | end-to-end ]
Lets you check the ATM connection reachability and network connectivity. This command sends five
Operations, Administration, and Maintenance (OAM) loopback calls to the specified vpi/vci destination.
There is a five second total timeout inter val.
Use the segment argument to ping a neighbor switch.
Use the end-to-end argument to ping a remote end node.
reset dhcp client release [ vcc-id ]
Releases the DHCP lease the Motorola Netopia
®
Gateway is currently using to acquire the IP settings
for the specified DSL por t. The vcc-id identifier is an “index” letter in the range B-I, and does not
directly map to the VCC in use. Enter the reset dhcp client release command without the
variable to see the letter assigned to each vir tual circuit.
reset dhcp client renew [ vcc-id ]
Releases the DHCP lease the Motorola Netopia
®
Gateway is currently using to acquire the IP settings
for the specified DSL por t. The vcc-id identifier is an “index” letter in the range B-I, and does not
directly map to the VCC in use. Enter the reset dhcp client release without the variable to
see the letter assigned to each vir tual circuit.
reset dsl
Resets any open DSL connection.
reset ppp vccn
Resets the point-to-point connection over the specified vir tual circuit. This command only applies to vir-
tual circuits that use PPP framing.
show atm [all]
Displays ATM statistics for the Motorola Netopia
®
Gateway. The optional all argument displays a more
detailed set of ATM statistics.
show dsl [ all ]
Displays DSL por t statistics, such as upstream and downstream connection rates and noise levels.