FARGO electronic DTC300 User Manual
Page 98
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
5-25
Resolving a No Ribbon Installed Error (continued)
Step Procedure
2
Verify that a Ribbon Cartridge is installed in the Printer.
a. Press on the Resume button.
b. If the issue persists, continue to Step 3.
3
Remove the rear cover and check that the Ribbon RFID cable is securely
connected to the Main Board (J-5) and the RFID Sensor.
•
If the connections are loose, reattach them.
•
Press on the Resume button.
•
If the connections are good or if the issue persists, continue to Step 4.
4
Replace the Ribbon RFID Sensor.