FARGO electronic DTC300 - Manual (Page 321)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-67
Replacing the Input Feed Motor Assembly (D900084)
Refer to Drawings D900077.
Tools Needed: Phillips Head Screwdriver.
Parts Needed: Input Motor Assembly D900084
Estimated Repair Time: 15 minutes.
Steps Procedures
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2 Remove the Rear Cover. See Replacing the Rear Cover (D900066) .
3 Remove the Input Door and Right End Cap. See Replacing the Input Door
Assembly (D900148) . See Replacing the Right End Cap (D900065-01 and –
02) .
4 Remove the Card Output Door and Left End Cap. See Replacing the Output
Door Assembly (D900092) . See Replacing the Left End Cap (D900064) .
5 Use a Torx T-10 screwdriver to remove the three (3) screws (F000177) that
secure the Card Feed Input Motor Assembly to the Printer. See the frontend
display with this set of procedures.
6 Disconnect the Input Motor power cable.
7 Push the Card Hopper to locked down position