FARGO electronic DTC300 User Manual
Page 302
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8-48
Replacing the Baseplate (D900000) (continued)
Steps Procedure
10
a. Use a needle nose pliers to firmly grasp the Card Hopper spring Shaft
(D900052), as shown below.
b. Use a No. 2 Phillips screwdriver to remove the one (1) Card Hopper Spring
Shaft mounting screw (F000231), as shown below.
11
Lift the back of the Baseplate up and then pull out to remove it.
Continued on the next page