Cover, door and tray removal – FARGO electronic DTC300 User Manual
Page 277
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8-23
Cover, Door and Tray Removal
Replacing the Rear Cover (D900066)
Refer to Drawings D900148.
Tools Needed: Phillips Head Screwdriver.
Parts Needed: D900066 Rear Cover.
Estimated Repair Time: 2 to 5 minutes.
Steps Procedure
1
Caution: Turn off the Printer and unplug the power cord from the
Printer.
2
Use a No. 2 Phillips screwdriver to remove the two (2) screws (130984) that
secure the Rear Cover to the Baseplate, as shown in the lower middle left and
lower right of the photo below.
3
Remove the Rear Cover. See
Replacing the Rear Cover (D900066)
.
Continued on the next page