FARGO electronic DTC300 - Manual (Page 301)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 8-47
Replacing the Baseplate (D900000) (continued)
Steps Procedure
7 Use a 7/32 nd nut driver to remove the one (1) nut (130985) that secures the
ground cables to the Baseplate.
8 Disconnect the Communication Ribbon Wire (D900034) from the J7 Main Board
connection.
9 Turn the Printer over.
Continued on the next page