FARGO electronic DTC300 - Manual (Page 399)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 12-1
Section 12: Firmware Upgrades
Introduction
The DTC400/DTC300/DTC300M Card Printer/Encoders - Firmware Upgrade Document
(Rev. 1.3) and this section are identical. They both provide step-by-step procedures for
upgrading the Firmware on these Printers.
Requirements
• Windows 32 bit Operating System (XP/2000)
• Internet Access
Table of Contents
Section 12: Firmware Upgrades_____________________________________________ 12-1
Introduction _______________________________________________________________________ 12-1
Requirements______________________________________________________________________ 12-1
Table of Contents __________________________________________________________________ 12-1
Safety Messages (review carefully)_____________________________________________________ 12-2
Downloading Firmware______________________________________________________________ 12-3
Downloading Firmware (continued) _______________________________________________ 12-4
Downloading Firmware (continued) _______________________________________________ 12-5
Downloading Firmware (continued) _______________________________________________ 12-6
Downloading Firmware (continued) _______________________________________________ 12-7
Downloading Firmware (continued) _______________________________________________ 12-8
Downloading Firmware (continued) _______________________________________________ 12-9
Downloading Firmware (continued) ______________________________________________ 12-10
Downloading Firmware (continued) ______________________________________________ 12-11
Downloading Firmware (continued) ______________________________________________ 12-12
Downloading Firmware (continued) ______________________________________________ 12-13
Downloading Firmware (continued)_________________________________________________ 12-14
Downloading Firmware (continued) ______________________________________________ 12-15
Downloading Firmware (continued) ______________________________________________ 12-16
Placing the Printer in the Firmware Upgrade Mode _______________________________________ 12-17
Placing the Printer in the Firmware Upgrade Mode (continued) _________________________ 12-18
Sending the Firmware File __________________________________________________________ 12-19
Sending the Firmware File (continued) ____________________________________________ 12-20