FARGO electronic DTC300 User Manual
Page 322
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3)
8-68
Replacing the Input Feed Motor Assembly (D900084) (continued)
Steps Procedures
8
Pull the Motor/Roller Assembly out of the Printer.
•
Note 1: The access hole for the Card Input Roller is virtually the same size
as the Roller so some force will be needed to put the Roller through the
hole.
•
Note 2: Be sure to remove any grease off of the Card input Access hole
before you insert a new Roller into the hole.
9
Reverse to re-assemble.
Continued on the next page