FARGO electronic DTC300 - Manual (Page 172)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 6-43
Using the Overlay Heat (O) option
Use this option to control the amount of heat the Printer uses when printing with the overlay
panel of a Ribbon. (Note: This control can be helpful for fine-tuning the transfer of overlay
onto the card.)
Step Procedure
1 Move the slide to the left to cause less heat to be used in the printing process.
(Note: Certain card types may need additional heat for better transfer of the
overlay material.)
OR
Move the slide to the right to cause more heat to be used.