FARGO electronic DTC300 - Manual (Page 90)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer Service Manual (Rev. 1.3) 5-17
Resolving the No Mag Installed Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: There is not a Magnetic Encoder installed.
• Printer Error State: A print job with Magnetic encoding was sent with no
Magnetic encoder installed in the Printer.
• LCD Error Display: No Mag Installed
• Driver Monitor Error Display: No Mag Installed