FUJITSU M3093DG - Manual (Page 86)

(1) SET WINDOW command: COMMAND phase (initiator Æ target)
The SET WINDOW command is used to set a window.
The CDB of this command is shown in the following illustration.
8
Byte 0
7
(Reserved)
Operation code X©24π
2
5
1
7 6 5 4 3 2 1 0
9
6 (MSB)
Transfer length
(LSB)
(Reserved)
Control byte
Logical unit number
a. TRANSFER LENGTH: Bytes 6 to 8
Specifies the number of window data bytes sent in the DATA OUT phase.
A zero (0) means that no data is to be transferred; this situation is not
considered an error.
If the number of bytes is not enough (less than 48) to set a window, the scanner
returns the following error information:
f Status: B©00001π (CHECK CONDITION)
f Sense key: X©5π (ILLEGAL REQUEST)
4 $ 54