FUJITSU M3093DG - Manual (Page 54)

4.4 Commands
Commands are directions issued from an initiator to a target. This image scanner
supports the following range of the commands specified by the SCSI standard.
(a) The identification number of logical unit (LUN: logical unit number) is B©000π.
If this scanner receives a value other than 000, it returns error information as
follows:
f Status key: B©00001π (CHECK CONDITION)
f Sense key: X©5π (ILLEGAL REQUEST)
(b) Relative addressing is not supported.
If this scanner receives a relative address (RelAdr) = 1, it returns error
information as follows:
f Status key: B©00001π (CHECK CONDITION)
f Sense key: X©5π (ILLEGAL REQUEST)
(c) A control byte is not supported.
If this scanner receives a control byte b X©00π , it returns error information as
follows:
f Status key: B©00001π (CHECK CONDITION)
f Sense key: X©5π (ILLEGAL REQUEST)
(d) A bit and field described as ™Reserved∫ are 0.
If this scanner receives a value other than 0, it returns error information as
follows:
f Status key: B©00001π (CHECK CONDITION)
f Sense key: X©5π (ILLEGAL REQUEST)
The commands supported by this scanner are listed below.
4 $ 22