FUJITSU M3093DG User Manual
Page 104
If undefined value is specified this scanner returns the following error
information:
f
Status:
B©00001π (CHECK CONDITION)
f
Sense key: X©5π (ILLEGAL REQUEST)
f
Paper width X, paper length Y: bytes 36 to 39, 3A to 3D (front>side
window data only)
These parameters are valid when the nonstandard size is specified in
the paper size parameter (byte 35).
The paper width and length is specified in 1/1200 inches unit.
If the window data is back>side, these bytes must be all X©00π.
Notes:
1. If the ADF is used and this parameter has not been specified, the paper is
scanned on the default paper size (A3: M3096GX, A4: M3093GX/DG) of
this scanner.
2. The paper size specified here concerns the sheets loaded in the ADF.
The area specified by the WINDOW bytes 6 to 15 in the window data should
be equal to or smaller than the specified paper size.
3. The ADF for this scanner positions paper relative to the center.
Therefore, if paper size is not specified in the window data bytes 6 to 15, the
window cannot be accurately positioned for the paper.
4. This parameter is only effective for reading with the ADF.
4 $ 72