FUJITSU M3093DG - Manual (Page 200)

E.2 Change from M3093GX or M3096GX to M3097G
a) Verify the scanner power is turned off.
b) Open the ADF cover and turn on the power while pressing the following
switches;
in case of M3093GX: OMR sensor and B5 sensor (See Figure E.1)
in case of M3096GX: OMR sensor and A4 sensor (See Figure E.1)
c) The PRODUCT IDENTIFICATION is switched from "M3093GX", "M3096GX"
to "M3097G". If PRODUCT IDENTIFICATION has already changed to
"M3097G", it will be reset to "M3093GX", "M3096GX". The transition status is
recognized by the LEDs.
Transition POWER READ CHECK
M3093/96GX Æ M3097G Blinking Blinking Turn on
M3097G Æ M3093/96GX Blinking Turn on Turn off
d) When transition status is recognized, close the ADF cover and turn off the
Power>switch.
e) From the next Power>on, changed PRODUCT IDENTIFICATION is returned.
Only the product name is changed. Lower>case characters those indication option
are not affecte, just like the case of M3096G.
E $ 4