FUJITSU M3093DG - Manual (Page 133)

c. Mode page
The mode page format is indicated for each page code.
f Page cod e
The PAGE CODEs supported in this scanner are as follows:
Page code Description
X©00π Donπt care (IGNORE)
Xπ01π Reserved
X©02π Not supported
X©03π Not supported
X©04π to X©3Bπ Reserved
X©3Cπ Auto size detection (M3093DG only)
X©3Dπ Lamp timer
X©3Eπ Job separation sheet
X©3Fπ Reserved
Each page is described below.
— Auto size detection (PAGE CODE X©3Cπ) (M3093DG only)
Byte 0
1
2
3
4
7
(Reserved) PAGE CODE (X©3Cπ)
(Reserved)
7 6 5 4 3 2 1 0
Parameter length (X©06π)
to
(Reserved)
AWD
ALD
(Reserved)
f AWD (Automatic Width Detection): Byte 2
The AWD bit specifies detected paper width replaces width value which has
specified in Width field in Set Window Parameter. When this bit is 0,
automatic width detection is disabled. When this bit is 1, automatic width
detection is enabled. After the scanning, detected width is set in Detected
Paper Width field of Pixel Size Data.
The AWD bit is reserved now. If 1 is set to this bit, the scanner returns
following error information.
Status : B©00001π (CHECK CONDITION)
Sense Key : X©5π (ILLEGAL REQUEST)
4 $ 101