FUJITSU PRIMERGY RX900 S1 - Manual (Page 60)

60 Maintenance Manual RX900 S1
Power supply
5.3.3 Removing the power supply unit
Figure 16: Unlocking and removing the power supply unit
Ê Remove the power cord from the cable strap. You can loosen the cable strap
by opening the small locking lever.
Ê Remove the power cord from the installed power supply unit.
Ê Press the green release lever (1) and pull out the power supply unit in the
direction of the arrow (2). Grip the handle while pulling the power supply.
Ê Completely remove the defective power supply unit from the bay.
V
CAUTION!
Never leave the bay for the power supply unit empty for more than two
minutes during operation. Otherwise, excessive temperatures could
damage system components.
/
0