FUJITSU PRIMERGY BX600 - Manual (Page 67)

Panel Settings Menu
Web-Based Management Interface
Intelligent Blade Panel Module
66
6.2.2.1.4 Configuring Telnet Session Page
Configurable Data
Telnet Session Timeout (minutes) - Specify how many minutes of inactivity should
occur on a telnet session before the session is logged off. You may enter any number
from 1 to 160. The factory default is 5.
Maximum Number of Telnet Sessions - Use the pulldown menu to select how many
simultaneous telnet sessions will be allowed. The maximum is 5, which is also the factory
default.
Allow New Telnet Sessions - If you set this to no, new telnet sessions will not be
allowed. The factory default is yes.
Password Threshold - When the logon attempt threshold is reached on the console port,
the system interface becomes silent for a specified amount of time before allowing the
next logon attempt. (Use the silent time command to set this interval.) When this
threshold is reached for Telnet, the Telnet logon interface closes. The default value is 3.
Command Buttons
Submit
- Update the IBP module with the values on the screen. If you want the IBP
module to retain the new values across a power cycle you must perform a save