FUJITSU PRIMERGY BX600 - Manual (Page 134)

CLI Mode-based Topology Command Reference
Intelligent Blade Panel Module
133
Conventions
Network addresses are used to define a link to a remote host, workstation, or network.
Network addresses are shown using the following syntax:
Table 5-1. Network Address Syntax
Address Type Format Range
IPAddr A.B.C.D 0.0.0.0 to 255.255.255.255
MacAddr YY:YY:YY:YY:YY:YY hexidecimal digit pairs
Double quotation marks such as "System Name with Spaces" set off user defined strings.
If the operator wishes to use spaces as part of a name parameter then it must be enclosed in
double quotation marks.
Empty strings (““) are not valid user defined strings. Command completion finishes
spelling the command when enough letters of a command are typed to uniquely identify the
command word. The command may be executed by typing (command abbreviation) or
the command word may be completed by typing the or (command
completion).
The value 'Err' designates that the requested value was not internally accessible. This
should never happen and indicates that there is a case in the software that is not handled
correctly.
The value of '-----' designates that the value is unknown.
Annotations
The CLI allows the user to type single-line annotations at the command prompt for use
when writing test or configuration scripts and for better readability. The exclamation point (‘!’)
character flags the beginning of a comment. The comment flag character can begin a word
anywhere on the command line and all input following this character is ignored. Any command
line that begins with the character ‘!’ is recognized as a comment line and ignored by the
parser.
Some examples are provided below:
! Script file for displaying the ip interface
! Display information about interfaces
show ip interface 0/1 !Displays the information about the first interface
! Display information about the next interface
show ip interface 0/2
! End of the script file