FUJITSU PRIMERGY BX600 - Manual (Page 165)

Device Configuration Commands Command Reference
Intelligent Blade Panel Module
164
no - This command move the port to active-port list.
Restriction: users are not allowed to move the last member of active port to backup port.
Default Setting
None
Command Mode
Interface Config
7.4.8 Link State
7.4.8.1 Show Commands
This command display the linkstate information.
Syntax
show linkstate []
- The name of a uplink set which user want to display.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Uplink Set Name: This indicates the name of uplink set
Linkstate:
. This indicates linkstate is enabled or disabled for this uplink set.
7.4.8.2 Configuration Commands
7.4.8.2.1 linkstate
This command is used to enable or disable linkstate for a uplink set
Syntax