FUJITSU PRIMERGY BX600 - Manual (Page 283)

The default settings for all the configuration commands Default Settings
Intelligent Blade Panel Module
282
SSL HTTP Mode (Secure): Disabled
Secure Port: 443
Secure Protocol Level(s): TLS1 SSL3
802.1X Port Authent. disable
RADIUS Client
disable
IGMP Snooping disable
802.3ad enable
SNTP Client disable
TACACS disable
StormControl enable
Link State disable
Port-Backup disable
SNMP
9.2 The default settings for all the configuration commands
The default settings for all the configuration commands are shown in the following
table.
SB9 DEFAULT CONFIG
configure mode
Sntp sntp unicast client poll-interval 6
sntp unicast client poll-timeout 5
sntp unicast client poll-retry 1
sntp broadcast client poll-interval 6
sntp client port 123
sntp clock timezone Taipei 8 0 before-utc
logging buffered logging buffered
logging buffered wrap
no logging console
no logging syslog
no logging syslog port